****JavaScript based drop down DHTML menu generated by NavStudio. (OpenCube Inc. - http://www.opencube.com)****
 |
|||||||||||||||||||
|
|||||||||||||||||||
| Question: | |||||||||||||||||||
 |
|||||||||||||||||||
| Is there a limit to handling capacity? | |||||||||||||||||||
| Answer: | |||||||||||||||||||
|
|||||||||||||||||||
| No. We manufacture conveyors with belt widths from 12" to 72" wide. The cross section on the belt is equal to a 45º troughing idler. The trough is a concave curve which eliminates the belt cover from cracking at the pinch points, which is experienced in conventional 45º idler conveyors. The belt sag between idler rolls is also eliminated. The belt is supported for its entire troughing length, which eliminates idler bumping. On idler conveyors, the bumping causes material to be thrown up every time it goes over an idler, thus causing dust generations, product separation and degradation. | |||||||||||||||||||
| << Frequently Asked Questions Main Menu | |||||||||||||||||||
 |
|||||||||||||||||||
|
Copyright © 2005 The Hendrik Group Incorporated
All Rights Reserved |
|||||||||||||||||||
